Page 1 of 1
ported and polished head
Posted: Wed Apr 17, 2013 8:04 pm
by FrontBackSide2Side
i bought a ported and polished head off ebay a few months ago on a bit of a whim. Trouble is i dont know who did the work and if it is any good or not so im a bit apprehensive to use it. is there a way i can get it tested on a flow bench etc? baring in mind its a bare head, no valves or cams etc
Posted: Wed Apr 17, 2013 9:37 pm
by honda-hardy
the best thing to do is in online and find a machining company that does the head skimming and pressure testing. Get then to look over it.
Posted: Wed Apr 17, 2013 9:38 pm
by 4thgenphil
honda-hardy wrote:the best thing to do is in online and find a machining company that does the head skimming and pressure testing. Get then to look over it.
i would say get it flow tested aswell just to check they are flowing equally aswell!
PAW?