Page 1 of 2
OEM switch that will fit here
Posted: Wed Aug 22, 2012 10:40 pm
by prelude_h22
Hi All
Just wondering if anyone has had a honda Latching OEM switch fitted here? (circled in red)
I am looking to re-wire something here and not keen using any random switch and want to keep it OEM as possible if i can.
If so which one did you fit?
Cheers All
Posted: Wed Aug 22, 2012 10:48 pm
by Dbo
don't want to thread jack
but in the 4th gen we have a little vent/switch hole in the same place, but in my ukdm it was just a blanking cover that i was going to put the starter button in.
but in the jdm it is a little slatted grill and behind it is a large loom of some sort?
does any one know what it is for and can it be removed? so i can have my starter button there?
Posted: Wed Aug 22, 2012 10:50 pm
by nitin_s1
JDM cars have digital climate control sensor there, so in the UKDM there's only a shity blanking plate.
Posted: Wed Aug 22, 2012 10:51 pm
by nitin_s1
You can put a S2000 starter button there. I've seen it and it look nice and OEM there.
Posted: Wed Aug 22, 2012 10:51 pm
by Dbo
nitin_s1 wrote:JDM cars have digital climate control sensor there, so in the UKDM there's only a shity blanking plate.
cheers
better not rip it out then
Posted: Wed Aug 22, 2012 10:52 pm
by jjmartin349571
I think it's the cabin temperature sensor for the climate control
*Edit* argh you beat me to it Nitin!
Posted: Thu Aug 23, 2012 6:18 pm
by aardvark64
The double bank of switches from a 3rd gen will fit there: is that the sort of mod' you have in mind?
Best wishes, Colin
Posted: Thu Aug 23, 2012 6:19 pm
by Donald
I don't even have a blanking thing I don't think
Posted: Thu Aug 23, 2012 7:01 pm
by nickyboy
The EP3 has the same thing in the same place, I put my S2000 starter button in there.
Just noticed you have the EP3 steering wheel too
Posted: Thu Aug 23, 2012 7:19 pm
by nitin_s1
Gorgon wrote:I don't even have a blanking thing I don't think
Check again!
