5th Gen Seats

Post by **NafemanNathan** » Sat Feb 21, 2015 8:15 pm

Cheers Donald. Might pop mine out tomorrow then

Did you check out the driver's seat by chance? Is there means for that to tilt and slide in one motion?

Post by **Donald** » Sat Feb 21, 2015 8:36 pm

I checked and there wasn't one on the driver's side. I was in a bit of a rush so didn't spend long looking tbh but I'm sure it would be an easy enough job to retrofit a spring (if there isn't already the means to attach one). I can have a closer look in the morning before they go to their new owner.

I've no doubt you've figured it out but it's just a spring attached to the seat pan and a stationary point on the rail rather than a mechanism built into the tilty bit. Low tech jobby.

Post by **NafemanNathan** » Sat Feb 21, 2015 10:41 pm

If the seats are out it'd be good if you could just have a glance to see it the driver's has a provision for it. Not to worry otherwise... It's only 4 bolts