not new but new lude :D
Posted: Sun Apr 20, 2014 3:22 pm
Well guys, i finally got another lude on Friday 
i bought it off 4th gen Phil and let me say what a fantastic guy he is, the car was spot on and exactly as he had told me. I recommend anyone to buy from him.
Onto the car
Its a J reg BB4 H22a Auto with 135,000km on it in phantom grey and the arches are mint, not a mark on them.
Mods:
Tanabe cat back exhaust with an unnamed system to the engine
K and N panel Filter
Mugen rear spoiler
I also got given with the car a full manual conversion (minus the loom) so the plans for the next few months are as follows:
- find a full manual jdm loom with digi speedo clocks and fit manual conversion
- may remove spoiler as i have a standard one to put on (depends on interest when i list)
-may remove exhaust and fit a slash cut one as personally don't like the one on now (depends on interest when i list)
- euro r inlet manifold and throttle body (find and put on)
-h22a7 cams/head (find and put on)
-may remove alloys and put 17'' on as with the 16'' it is very very very low to the floor (depends on interest when i list)
i will list some pictures now on a reply underneath.
Cant wait to meet some more people off this forum, and cant wait to start spending some money on her any help would be greatly appreciated.
Cheers
Steve
i bought it off 4th gen Phil and let me say what a fantastic guy he is, the car was spot on and exactly as he had told me. I recommend anyone to buy from him.Onto the car
Its a J reg BB4 H22a Auto with 135,000km on it in phantom grey and the arches are mint, not a mark on them.
Mods:
Tanabe cat back exhaust with an unnamed system to the engine
K and N panel Filter
Mugen rear spoiler
I also got given with the car a full manual conversion (minus the loom) so the plans for the next few months are as follows:
- find a full manual jdm loom with digi speedo clocks and fit manual conversion
- may remove spoiler as i have a standard one to put on (depends on interest when i list)
-may remove exhaust and fit a slash cut one as personally don't like the one on now (depends on interest when i list)
- euro r inlet manifold and throttle body (find and put on)
-h22a7 cams/head (find and put on)
-may remove alloys and put 17'' on as with the 16'' it is very very very low to the floor (depends on interest when i list)
i will list some pictures now on a reply underneath.
Cant wait to meet some more people off this forum, and cant wait to start spending some money on her
any help would be greatly appreciated.Cheers
Steve
bonus that you have the stuff for manual conversion too.