BB4 bye,bye

Post by **newkid** » Fri May 15, 2015 10:23 am

that is all

Post by **vanzep** » Fri May 15, 2015 10:25 am

if it all works out!

Post by **NafemanNathan** » Fri May 15, 2015 10:33 am

vanzep wrote:Ive got the switch installed on the loom that was already there and i have the jumper/extender harness just need to find the plug on the loom under the dash and plug it all in - well thats the plan anyway

Got to cut your holes out as well

Post by **vanzep** » Fri May 15, 2015 10:49 am

yep got to do the cut outs in the front bumper for the fog lights but it doesnt look to difficult to do

im going to try and do it with the bumper on the car hoping thats possible as i dont have the engine splash guard fitted......and im waiting for the bezels to arrive.
Ive found one plug on the loom for the passenger side fog but havent been able to find the one on the drivers side yet

there is the remnants of a broken plug on that side but i hoping thats for something else

Post by **NafemanNathan** » Fri May 15, 2015 10:52 am

I think the foglight cutouts are marked on the back side of the bumper, so hopefully you can see those, but it'd certainly be easier to remove the bumper to do.

JDM-BB4 · Post by **JDM-BB4** » Fri May 15, 2015 7:41 pm

Nice updates!

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Sat May 16, 2015 12:37 am

you've refurbed those fogs?

they absolutely brand spanking new!

Post by **vanzep** » Sat May 16, 2015 9:08 am

yeah the fogs were a bit of a challenge to refurb - all the parts were coated in a thick layer of silver hammerite and all the screws were rusted in

i have another couple of sets - one clear and one yellow - still to decide what to do with them

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Sat May 16, 2015 12:22 pm

I've been uncovering several sets during the move from the shed to the barn, too

Post by **vanzep** » Tue May 19, 2015 6:08 pm

Picked up the car this afternoon.
Its been in to get the cams fitted,timing done and valve clearances and rocker cover gasket and cam end cap
Previous sets of cams were both out and id had to turn the disti right to the firewall to compensate.
The mechanic said he was surprised that it ran at all

Well it ran pretty good before ... will find out later on how well its going now

The old cams look worn out

Lude Generation

BB4 bye,bye

Re: BB4 Stage 1 (Cams)

Re: BB4 Stage 1 (Cams)

Re: BB4 Stage 1 (Cams)

Re: BB4 Stage 1 (Cams)