Lude Generation

Howdy folks, I'm ready to start rebuilding my rear suspension after completing the front end but I can't seem to find any rear upper control arms anywhere online.
Can anybody point me in the right direction please?
I'm pretty much looking for all other rear components too.
Any help would be very much appreciated.

Right hand side

Is it new? Also, do 4th gen control arms fit on a 5th gen please?

Do you need some help with part numbers, might make it easier to find.

4th gen will fit but 5th gen are better as they have a reinforcing plate, a known mod people do to 4th gen ones...

I have a pair of OEM rear upper wishbones but im not sure if i would trust the ball joints, they're not too difficult to replace though i did mine for £25, all i needed was some appropriately sized sockets and a vice.

Also are you 4WS? The ball joints for those are where you're going to struggle, but if 2WS you can still get OEM lower control arm B and through Amayama they're not too badly priced, cheaper than the Megan Racing arms which i ended up buying as Honda prices were silly and i didnt know about Amayama at the time.

You can replace the bushes in lower control arm A with poly from Strongflex or Energy Suspension (there's probably others), not sure about rubber ones as i did full poly from ES.

Are you going coilovers or shocks and springs as i just bought all new top mount bushes and i was a bit shocked at the difference between them and the old ones.

Thank you very much for the reply. Yeah, it's a 5th gen with 4WS.
Certain parts seem to be getting thin on the ground these days alright. I'm just looking to refresh it all at the moment if I can. I'd absolutely love to go nuts on it but I've blown a fortune on it already over the winter and I've just finished the front!

You've already gone nuts on it why stop now?

I would just replace all ball joints and bushes, these are the ball joints i fitted but take note of the orientation when you refit as they have limited side travel: https://www.ebay.co.uk/itm/303124603067 ... xyshFRfJ8z

As far as bushes are concerned im not sure where you would find them just for the wishbones, mine were part of the ES kit, if they're not knocking i would just clean them up and paint them.

You're going to struggle to find new parts cheap if at all, i would refurbish what you already have.

Thank you very much for the link, it's nice to know what options I have, or not!
I'm in up to my neck at this stage so I have to just keep swimming until it's done.

I get most of my parts from www.rockauto.com
They have them on there.

Hagland-BB4 wrote: ↑

Sat Mar 19, 2022 6:39 pm

I get most of my parts from www.rockauto.com
They have them on there.

Are they an American supplier, please?

I use them too, parts come quickly and you get free fridge magnets too.