Harness/wiring

sol-lude · Post by **sol-lude** » Mon Jul 17, 2017 11:56 pm

As some or probably all that I've pestered or bothered I'm doing an EL dial conversion however I believe I have an issue.
I think I'm missing a section of the wiring for the dials.

From what I can tell there is a green plug in the inventor that attaches to the dials themselves.

Someone is bound to have it lying around or possibly a spare they would be willing to sell without the full dials again.

Any assistance would be appreciated

Post by **vanzep** » Tue Jul 18, 2017 9:48 am

will have a check later on today - ive got the loom section you need but its part of a full ukdm facelift loom so dont want to take that off - but i might have some spare green connectors etc - pm me you mobile number and i will check and call you this avo

sol-lude · Post by **sol-lude** » Tue Jul 18, 2017 10:20 am

It's the plug that fits here

Sent from my SM-G935F using Tapatalk

Post by **vanzep** » Tue Jul 18, 2017 1:51 pm

All the spare connectors i have wont fit - ive tried them on a spare invertor - "close but no cigar"

I do have 2 sets of ukdm el dials with the silver box attached so they both have the short loom that goes from the back of the clocks to the box but i am keeping them in place as without them the el dials are useless

sol-lude · Post by **sol-lude** » Tue Jul 18, 2017 2:01 pm

vanzep wrote:without them the el dials are useless

this is my issue haha "I just don't have the power Cap'n"

Lude Generation

Harness/wiring

Harness/wiring

Re: Harness/wiring