Page 1 of 2
H22A engine for conversion
Posted: Thu Nov 27, 2014 10:25 pm
by hoppi05
Evening all, I am new to this forum but post a lot on some of the other well know honda forums like delsoluk and civiclife etc. As the tile suggests I am needing some parts to do a conversation to a h22a power plant.
Parts needed are:
H22a either full conversion or -
Alternator
Ecu pref JDM
Dizzy
Inlet manifold throttle body with sensors
Fuel rail with injectors
96 prelude engine side mount
h22 manifold
h22 flywheel cover
Cheers Hoppi....
Posted: Thu Nov 27, 2014 10:32 pm
by mercutio
@Bri has a good engine
Posted: Fri Nov 28, 2014 12:12 am
by K30DPC
I have full intake side. Make me an offer
Re: H22A engine for conversion
Posted: Fri Nov 28, 2014 6:23 am
by hoppi05
When you say full intake side what do you mean buddy? Sorry if I am miss reading it its very early....
Posted: Fri Nov 28, 2014 6:29 am
by Kristoffer
alright mate how are you ? and good luck with the build
Re: H22A engine for conversion
Posted: Fri Nov 28, 2014 7:59 am
by hoppi05
Morning buddy I am good thanks looking at the old H22 for more power
Posted: Fri Nov 28, 2014 8:56 am
by Drax
mercutio wrote:@Bri has a good engine
agreed,
@Bri will have a lot of what you need; engine, ecu, dizzy, inlet mani, h22 mani, h22 flywheel cover, mounts, rail etc
Re: H22A engine for conversion
Posted: Fri Nov 28, 2014 9:04 am
by hoppi05
That's again guys I will drop Bri a pm.
Re: H22A engine for conversion
Posted: Fri Nov 28, 2014 1:58 pm
by hoppi05
@Bri if you see this I think I have sent a msg over to you however from the phone it was hard to confirm???
Posted: Fri Nov 28, 2014 2:24 pm
by wurlycorner
So you have the engine and just need those ancillaries, right?
Whereabouts are you located?